UGA G
Without a CNC machine the edges are a little rougher With a CNC Machine the the edges can get a little smoother and more precise
Loose tooth? Not in the house of rockets!
Joshua had a loose tooth and really wanted to finish it off with a compressed air rocket launch… and recorded it in slow-motion video!
Smoke Test
Josh is testing his work on his control board for his 1 pound battle bot Would you believe it was a tiny little capacitor on the Arduino that popped?
Hot Air Balloon
Isabel had to make a hot air balloon for class. She made hers a little larger than average. She also has a spill line attached to the top of the…
The “Total Pratt Knot” (knecktie)
I dub thee: The Total Pratt Knot
Since I consider this is closer in affect to the Pratt than the Half-Windsor why should it be called the co-half-windsor
The co-half-windsor ( Li Ro Ci Ro Li Co T ) is the cousin to the Half-Windsor knot ( Li Ro Ci Lo Ri Co T ). In swapping two moves it remains similar in that it is tied right side out and absurdly considered “mathematically” asymmetrical (same number of L and R moves), but different in that it is visually symmetrical, self-releasing… and completely dismissed everywhere. I believe the visual symmetry is achieved through the obvious symmetry around the first Centring move – Li Ro Ci Ro Li – nearest the center are Ro moves on either side, followed by Li moves.
Water Rockets
Josh and Izzy has a history of aviation class any they had to make a few different types of vehicles. This particular lesson was a water rocket made with 2…
){kind=link}
